Webster IRP 4500 Guia de Instalação descarregar pdf (Página 21)

INSTALLING THE IRP 4500 19

SERIAL CABLE CONNECTION TO HOST COMPUTER

Your computer must have a spare serial port (COM port) to which the

Webster screen can be connected.

Connect the serial cable supplied with the IRP 4500 between your

computer and the Webster screen connector labeled “RS-232”

located at the left rear of the unit, above the accessory compartment

door.

If the supplied serial cable is not long enough, use a longer version

or add an extension. Use a 9-pin male to 9-pin female “IBM

compatible straight-through serial (RS-232) interface cable.” (Refer

to “Preparing to Install Cables” on page 15.)

NOTE:NOTE

The total length of an RS-232 cable and cable extension should

normally not exceed 50 feet. It is possible under favorable

circumstances to run a longer distance, but you will need to verify the

reliability.

RS-232

Projector

IRP_Install_1.fm Page 19 Monday, February 3, 2003 4:19 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 50 51

Sem comentários

Webster IRP 4500 Guia de Instalação Página 21